Loading... Please wait...





Step One:     Cut out the pre-printed toner graphic.
Step Two:     Lay the piece you just cut out, onto a carrier sheet. A carrier sheet can be as simple as a piece of cardstock. It holds/carries the graphic through the laminator and provides support so the rollers can apply even pressure as the foil is applied.
Step Three:     Cut a piece of foil large enough to fully cover the graphic.
Step Four:     Lay the foil COLOR SIDE UP, onto the graphic.
Step Five:    Send it through the laminator once. For best results, pass it through the laminator again but this time rotate it at a 90 degree angle.
Step Six:     Allow the graphic to completely cool. Using a foil applicator, gently burnish the foil onto the graphic. Then slowing from one corner, peel the foil back.